From: Harman Kalra <hkalra@marvell.com>
Date: Wed, 25 Aug 2021 17:48:41 +0530
Subject: octeontx2-af: nix and lbk in loop mode in 98xx
Patch-mainline: v5.15-rc1
Git-commit: aefaa8c71555de4db7fc8d9247a2c896dfdf0eb0
References: jsc#SLE-24682

In 98xx, there are 2 NIX blocks and 4 LBK blocks present. The way
these NIX-LBK should be configured depends on the use case. By
default loopback functionality is supported in AF VF pairs which
are attached to NIX0 and NIX1 LFs alternatively to ensure load
balancing. NIX0 transmits a packet to LBK1 which will be received
by NIX1 and packet transmitted by NIX1 will get received by NIX0 via
LBK2.

There are some requirements where only one AF VF is used and respective
NIX is expected to operate in a mode where it can receive it own packet
back. This can be achieved if NIX0 sends packet to LBK0 and not LBK1.
Adding a flag in LF alloc request mailbox which can setup NIX0 to use
LBK0 and NIX1 can use LBK3.

Signed-off-by: Harman Kalra <hkalra@marvell.com>
Signed-off-by: Sunil Goutham <sgoutham@marvell.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Acked-by: Thomas Bogendoerfer <tbogendoerfer@suse.de>
---
 drivers/net/ethernet/marvell/octeontx2/af/mbox.h    |    1 
 drivers/net/ethernet/marvell/octeontx2/af/rvu.h     |    1 
 drivers/net/ethernet/marvell/octeontx2/af/rvu_nix.c |   29 +++++++++++++++++---
 3 files changed, 28 insertions(+), 3 deletions(-)

--- a/drivers/net/ethernet/marvell/octeontx2/af/mbox.h
+++ b/drivers/net/ethernet/marvell/octeontx2/af/mbox.h
@@ -705,6 +705,7 @@ struct nix_lf_alloc_req {
 	u64 rx_cfg;   /* See NIX_AF_LF(0..127)_RX_CFG */
 	u64 way_mask;
 #define NIX_LF_RSS_TAG_LSB_AS_ADDER BIT_ULL(0)
+#define NIX_LF_LBK_BLK_SEL	    BIT_ULL(1)
 	u64 flags;
 };
 
--- a/drivers/net/ethernet/marvell/octeontx2/af/rvu.h
+++ b/drivers/net/ethernet/marvell/octeontx2/af/rvu.h
@@ -243,6 +243,7 @@ struct rvu_pfvf {
 	u8	nix_blkaddr; /* BLKADDR_NIX0/1 assigned to this PF */
 	u8	nix_rx_intf; /* NIX0_RX/NIX1_RX interface to NPC */
 	u8	nix_tx_intf; /* NIX0_TX/NIX1_TX interface to NPC */
+	u8	lbkid;	     /* NIX0/1 lbk link ID */
 	u64     lmt_base_addr; /* Preseving the pcifunc's lmtst base addr*/
 	unsigned long flags;
 };
--- a/drivers/net/ethernet/marvell/octeontx2/af/rvu_nix.c
+++ b/drivers/net/ethernet/marvell/octeontx2/af/rvu_nix.c
@@ -291,7 +291,7 @@ static bool is_valid_txschq(struct rvu *
 }
 
 static int nix_interface_init(struct rvu *rvu, u16 pcifunc, int type, int nixlf,
-			      struct nix_lf_alloc_rsp *rsp)
+			      struct nix_lf_alloc_rsp *rsp, bool loop)
 {
 	struct rvu_pfvf *pfvf = rvu_get_pfvf(rvu, pcifunc);
 	struct rvu_hwinfo *hw = rvu->hw;
@@ -344,6 +344,25 @@ static int nix_interface_init(struct rvu
 		if (rvu->hw->lbk_links > 1)
 			lbkid = vf & 0x1 ? 0 : 1;
 
+		/* By default NIX0 is configured to send packet on lbk link 1
+		 * (which corresponds to LBK1), same packet will receive on
+		 * NIX1 over lbk link 0. If NIX1 sends packet on lbk link 0
+		 * (which corresponds to LBK2) packet will receive on NIX0 lbk
+		 * link 1.
+		 * But if lbk links for NIX0 and NIX1 are negated, i.e NIX0
+		 * transmits and receives on lbk link 0, whick corresponds
+		 * to LBK1 block, back to back connectivity between NIX and
+		 * LBK can be achieved (which is similar to 96xx)
+		 *
+		 *			RX		TX
+		 * NIX0 lbk link	1 (LBK2)	1 (LBK1)
+		 * NIX0 lbk link	0 (LBK0)	0 (LBK0)
+		 * NIX1 lbk link	0 (LBK1)	0 (LBK2)
+		 * NIX1 lbk link	1 (LBK3)	1 (LBK3)
+		 */
+		if (loop)
+			lbkid = !lbkid;
+
 		/* Note that AF's VFs work in pairs and talk over consecutive
 		 * loopback channels.Therefore if odd number of AF VFs are
 		 * enabled then the last VF remains with no pair.
@@ -355,6 +374,7 @@ static int nix_interface_init(struct rvu
 		pfvf->rx_chan_cnt = 1;
 		pfvf->tx_chan_cnt = 1;
 		rsp->tx_link = hw->cgx_links + lbkid;
+		pfvf->lbkid = lbkid;
 		rvu_npc_set_pkind(rvu, NPC_RX_LBK_PKIND, pfvf);
 		rvu_npc_install_promisc_entry(rvu, pcifunc, nixlf,
 					      pfvf->rx_chan_base,
@@ -1309,7 +1329,8 @@ int rvu_mbox_handler_nix_lf_alloc(struct
 	rvu_write64(rvu, blkaddr, NIX_AF_LFX_TX_PARSE_CFG(nixlf), cfg);
 
 	intf = is_afvf(pcifunc) ? NIX_INTF_TYPE_LBK : NIX_INTF_TYPE_CGX;
-	err = nix_interface_init(rvu, pcifunc, intf, nixlf, rsp);
+	err = nix_interface_init(rvu, pcifunc, intf, nixlf, rsp,
+				 !!(req->flags & NIX_LF_LBK_BLK_SEL));
 	if (err)
 		goto free_mem;
 
@@ -3766,6 +3787,7 @@ int rvu_mbox_handler_nix_set_hw_frs(stru
 	struct nix_txsch *txsch;
 	u64 cfg, lmac_fifo_len;
 	struct nix_hw *nix_hw;
+	struct rvu_pfvf *pfvf;
 	u8 cgx = 0, lmac = 0;
 	u16 max_mtu;
 
@@ -3822,7 +3844,8 @@ rx_frscfg:
 		link = (cgx * hw->lmac_per_cgx) + lmac;
 	} else if (pf == 0) {
 		/* For VFs of PF0 ingress is LBK port, so config LBK link */
-		link = hw->cgx_links;
+		pfvf = rvu_get_pfvf(rvu, pcifunc);
+		link = hw->cgx_links + pfvf->lbkid;
 	}
 
 	if (link < 0)