From: Vyacheslav Bocharov <adeep@lexina.in>
Date: Wed, 26 Jan 2022 10:39:05 +0300
Subject: Bluetooth: hci_h5: Add power reset via gpio in h5_btrtl_open
Patch-mainline: v5.18-rc1
Git-commit: adce573b927adf827f2f8627f05c2ba90031ebc9
References: jsc#PED-1407
Add power reset for bluetooth via enable-gpios in h5_btrtl_open function.
While testing the RTL8822CS SDIO WiFi/BT adapter, it was found that in
some cases the kernel could not initialize BT firmware. However,
manually resetting the adapter via gpio (off/on sequence) allows it to
start correctly.
Apparently, when the system starts, the adapter is in an undefined state
(including unknown gpio state after starting uboot). A forced reset helps
to initialize the adapter in most cases. It has been found experimentally
that 100 ms is sufficient for a reset.
Signed-off-by: Vyacheslav Bocharov <adeep@lexina.in>
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Acked-by: Lee, Chun-Yi <jlee@suse.com>
---
drivers/bluetooth/hci_h5.c | 5 +++++
1 file changed, 5 insertions(+)
--- a/drivers/bluetooth/hci_h5.c
+++ b/drivers/bluetooth/hci_h5.c
@@ -966,6 +966,11 @@ static void h5_btrtl_open(struct h5 *h5)
pm_runtime_enable(&h5->hu->serdev->dev);
}
+ /* The controller needs reset to startup */
+ gpiod_set_value_cansleep(h5->enable_gpio, 0);
+ gpiod_set_value_cansleep(h5->device_wake_gpio, 0);
+ msleep(100);
+
/* The controller needs up to 500ms to wakeup */
gpiod_set_value_cansleep(h5->enable_gpio, 1);
gpiod_set_value_cansleep(h5->device_wake_gpio, 1);